Go to www.awrcorp.com
Back to search page Click to download printable version of this guide.

Plot Load Pull Gamma Points from Measured Load Pull File: G_LPGPM

Summary

G_LPGPM is equivalent to the LPGPM measurement you can use to plot the impedance points from a load pull file. The main difference is that G_LPGPM uses generalized MDIF load pull files, allowing it to support swept parameter measurements.

Parameters

Name Type Range
Load Pull Data File Name Subcircuit A/B Wave load pull file or Derived Value load pull file.
Z0, real (ohms) Real 0.1 to 2500; the normalization impedance used to display the contours on the Smith Chart.
Z0, imag (ohms) Real -2500 to 2500; the normalization impedance used to display the contours on the Smith Chart.

Options

In addition to the standard parameters, you may need to specify the following swept parameters.

Sweep Description
F1 Fundamental frequency.
iPower Index into the values used for swept power.
harm Specifies the harmonic used for plotting data.
iGammaX One gamma sweep should be set to "Use for x-axis" defining the impedance sweep over which data is plotted.

Legal and Trademark Notice