Go to www.awrcorp.com
Back to search page Click to download printable version of this guide.

Max Value for Generalized Load Pull Data: G_LPCMMAX

Summary

G_LPCMMAX is used to compute the location and values at the maximum value point of a contour (the maximum returned from a G_LPCM measurement). It is intended for display on a Smith Chart to show the location of the maximum values. The actual value of the maximum can be read from the data cursor, or by adding a data marker to the point on the graph.

Parameters

Name Type Range
Load Pull Data File Name Subcircuit A/B Wave load pull file or Derived Value load pull file
Data for contour   Calculated Values
Z0, real (ohms) Real 0.1 to 2500; the normalization impedance used to display the contours on the Smith Chart.
Z0, imag (ohms) Real -2500 to 2500; the normalization impedance used to display the contours on the Smith Chart.
Gamma Grid Density   The density of the gamma grid used to interpolate load pull max and min values. "High" (the default) matches all previous values calculated by the measurement in earlier versions of Cadence® AWR® Microwave Office software. "Matched" matches the gamma grid density to the grid density used by the G_LPCM measurement.

Options

In addition to the standard parameters, you may need to specify the following swept parameters.

Sweep Description
F1 Fundamental frequency
iPower Index into the values used for swept power.
harm Specifies which harmonic to use.

Legal and Trademark Notice