Go to www.awrcorp.com
Back to search page Click to download printable version of this guide.

Inverted Stripline (EM Quasi-Static): SI1LIN

Symbol

Summary

SI1LIN models section of single stripline with a conductor strip placed on the lower surface of a suspended substrate (suspended substrate is a single layer substrate elevated over the infinite grounded plane).

Parameters

Name Description Unit Type Default
ID Element ID Text TL1
W Top Conductor width Length W[1]
L Conductor length Length L[1]
Acc Accuracy parameter   1
SPSUB Substrate Definition Text SPSUB1[2]

[1] User-modifiable default. Modify by editing under $DEFAULT_VALUES in the default.lpf file in the root installation directory. See the AWR Microwave Office Layout Guide for details.

[2] Modify only if schematic contains multiple substrates. See “Using Elements With Model Blocks” for details.

Parameter Details

SPSUB. Suspended substrate parameters are listed in SPSUB model description.

Acc. The parameter Acc is the accuracy parameter. The default value for Acc is 1. If Acc is less than 1 or greater than 10 it is set automatically to 2.

Parameter Restrictions and Recommendations

  1. Accuracy parameter Acc is limited to 1≤Acc≤10 . Larger value of Acc increases density of mesh used in computations. Accuracy of model parameters may gain slightly from increasing Acc at the expense of noticeable growth of computation time. As a rule of thumb, good trade-off between accuracy and computation time is to set Acc to 1.

  2. This component does not impose restrictions on the conductor thickness (thickness may be zero, positive, or negative). Negative thickness means that the conductor is recessed into the substrate.

Implementation Details

Model implementation is based on EM Quasi-Static technique described in [1]. It accounts for losses in metal and in substrate dielectric. Dispersion is partly included

Layout

This element uses line types to determine its layout. By default, the layout uses the first line type defined in your Layout Process File (LPF). You can change the element to use any of the line types configured in your process:

  1. Select the item in the layout.

  2. Right-click and choose Shape Properties to display the Cell Options dialog box.

  3. Click the Layout tab and select a Line Type.

  4. Click OK to use the new line type in the layout.

See “Cell Options Dialog Box: Layout Tab ” for Cell Options dialog box Layout tab details.

See “The Layout Process File (LPF)” for more information on editing Layout Process Files (LPFs) and to learn about adding or editing line types.

Recommendations for Use

NOTE: The implementation of EM Quasi-Static models relies heavily on the involved numerical algorithms. This may lead to a noticeable increase in simulation time for schematics that employ many such models.

If thickness of any layer is too small in comparison with the thickness of another layer, simulation time may also noticeably grow.

References

[1] M.B. Bazdar, A.R. Djordjevic, R.F. Harrington, and T.K. Sarkar, "Evaluation of quasi-static matrix parameters for multiconductor transmission lines using Galerkin's method," IEEE Trans. Microwave Theory Tech., vol. MTT-42, July 1994, pp. 1223-1228.

Legal and Trademark Notice