This signal source is superseded and should be replaced with one of the following: AC_V for voltage sources, AC_I for current sources, or PORT_SRC for ports, with the Signal parameter set to this signal type.
The period for tone 1 sources is the inverse of the specified simulation frequency; see “Frequency Sweep Control” for details.
|Z||Termination impedance||Resistance||50 ohm|
|AMP||Open circuit signal magnitude||Voltage||0 V|
|TD||Time delay||Time||0 ns|
|DCVal||DC Value (Used for DC analysis)||Voltage||0|
|PIN_ID||Name identifier for pin||Text|
This is an active circuit termination that applies a load resistance specified by Z while supplying a triangle-wave power swept across the frequency range specified for the schematic containing the port. The port number P is set automatically. If PIN_ID is not empty, text displays on the pin when it is instantiated as a subcircuit.
This element does not have an assigned layout cell. You can assign artwork cells to any element. See “Assigning Artwork Cells to Layout of Schematic Elements” for details.