Go to www.awrcorp.com
Back to search page Click to download printable version of this guide.

Bessel Narrowhead Bandpass Filter: NBPFD

Symbol

Summary

NBPFD models represent lumped-element Bessel-Thomson bandpass filters. The applicability of this filter type is not limited to narrow bandwidths, as the name would appear to imply. The group delay is flatter than that of a "regular" Bessel bandpass filter of the same bandwidth, especially for wideband filters. And the passband magnitude displays arithmetic, rather than geometric, symmetry. The Bessel-Thomson characteristic offers simplicity and maximally flat group delay, but suffers from poor selectivity.

Parameters

Name Description Unit Type Default
ID Element ID Text NBPFD1
N Number of resonators in the filter   3
FP1 Passband lower band-edge frequency (when Qu is infinite). Frequency 0.5 GHz
FP2 Passband upper band-edge frequency (when Qu is infinite). Frequency 1.5 GHz
AP Maximum Passband corner attenuation (when Qu is infinite). DB 3.0103 dB
*RS Expected source resistance. Resistance 50 ohm
*RL Expected Load resistance Resistance 50 ohm
*QU Average unloaded Q of filter resonators.   1e12

* indicates a secondary parameter

Parameter Restrictions and Recommendations

  1. 0 < N < 32

  2. 0 < FP1

  3. 0 < FP2

  4. 0 < AP Recommend AP greater than or equal to 0.001 dB.

  5. 0 < RS

  6. 0 < RL

  7. 0 < QU. Recommend QU less than or equal to 1e12.

Implementation Details

The model is implemented as a short-circuit admittance matrix,

, whose equivalent transfer function squared magnitude is that of a Bessel-Thomson filter:

where

Where b0 = (2N-1)!!,i.e, the product of all odd integers less than 2N.

and a lowpass-to-narrowband-bandpass frequency transformation has been applied:

This frequency transformation has good delay preserving properties for wide band filters and produces passband amplitudes with arithmetic symmetry. _FREQ is the variable containing the project frequency, and the admittances are:

Layout

This element does not have an assigned layout cell. You can assign artwork cells to any element. See “Assigning Artwork Cells to Layout of Schematic Elements” for details.

Recommendations for Use

Note that this model behaves as if it has ideal impedance transformers at its ports, so there is no attenuation due to mismatched source and load impedances. The model expects that the source impedance will equal RS and that the load impedance will equal RL, but RS need not equal RL for ideal transmission (as would normally be the case).

References

[1] Rolf Schaumann, Mohammed S. Ghausi, and Kenneth R. Laker, Design of Analog Filters: Passive, Active RC, and Switched Capacitor, (Prentice-Hall, 1990), pp. 51-56.

[2 ]Louis Weinberg, Network Analysis and Synthesis, (Robert E. Krieger Publishing, 1975), pp. 499-506.

[3] Herman J. Blinchikoff and Anatol I. Zverev, Filtering in the Time and Frequency Domains, (Robert E. Krieger Publishing Co., 1987), pp. 124-127.

[4] H. Blinchikoff, "A note on wide-band group delay," IEEE Trans. Circuit Theory, pp. 577-578, Sept. 1971.

Legal and Trademark Notice