MS2CLIN models section of two edge coupled asymmetric microstrip lines on a suspended substrate, that is, on a single layer substrate elevated over the infinite grounded plane.
|W1||Width of conductor 1||Length||W|
|W2||Width of conductor 2||Length||W|
|S||Spacing between conductors||Length||L|
MPSUB. Suspended substrate parameters are listed in MPSUB model description.
Acc. The parameter Acc is the accuracy parameter. The default value for Acc is 1. If Acc is less than 1 or greater than 10 it is set automatically to 2.
Accuracy parameter A is limited to 1≤Acc≤10 . Larger value of Acc increases density of mesh used in computations. Accuracy of model parameters may gain slightly from increasing Acc at the expense of noticeable growth of computation time. As a rule of thumb, good trade-off between accuracy and computation time is to set Acc to 1.
This component does not impose restrictions on the conductor thickness (thickness may be zero, positive, or negative). Negative thickness means that the conductor is recessed into the substrate.
Model implementation is based on EM Quasi-Static technique described in . It accounts for losses in metal and in substrate dielectric. Dispersion is partly included
This element uses line types to determine its layout. By default, the layout uses the first line type defined in your Layout Process File (LPF). You can change the element to use any of the line types configured in your process:
Select the item in the layout.
Right-click and chooseto display the Cell Options dialog box.
Click the Layout tab and select a Line Type.
Clickto use the new line type in the layout.
See “Cell Options Dialog Box: Layout Tab ” for Cell Options dialog box Layout tab details.
See “The Layout Process File (LPF)” for more information on editing Layout Process Files (LPFs) and to learn about adding or editing line types.
NOTE: The implementation of EM Quasi-Static models relies heavily on the involved numerical algorithms. This may lead to a noticeable increase in simulation time for schematics that employ many such models.
If thickness of any layer is too small in comparison with the thickness of another layer, simulation time may also noticeably grow.