 |
|
The following limitations apply to import of DXF files:
Extrusion thicknesses in DXF files are currently ignored.
Colors of the DXF elements are currently ignored.
Variable line width in DXF file is ignored. Instead, the start width of the line is applied to the entire line segment. If the start width is zero, the end width of the line segment is applied.
Variable polyline or lwpolyline width in DXF file is ignored.
When two line segments join at an angle and the shorter line segment length is considerably less than its width, the line is shown without the width.
The following DXF entities are currently supported:
LINE
POYLINE
LWPOLYLINE
CIRCLE
ARC
INSERT
BLOCK
DXF REGION entity is not supported.
Please send email to awr.support@ni.com if you would like to provide feedback on this article. Please make sure to include the article link in the email.