Go to www.awrcorp.com
Back to search page Click to download printable version of this guide.

5.2.7. Antennas

When setting up an antenna simulation, you need to consider a number of issues that aren't present in other RF3p simulations. This section describes these issues.

To trigger the near-to-far-field calculation and obtain antenna results, open the simulation setup dialog box and change the Antenna Far Fields Output Frequency from None to either All Frequencies or AMR Frequencies Only. Both All Frequencies and AMR Frequencies Only will trigger output of antenna results over the entire frequency spectrum. Choosing All Frequencies will also result in output of the complex electric and magnetic far fields and the power flux density over the entire frequency spectrum, while choosing AMR Frequencies Only will result in output of these far fields at just the AMR frequencies.

Please send email to awr.support@ni.com if you would like to provide feedback on this article. Please make sure to include the article link in the email.

Legal and Trademark Notice