Go to www.awrcorp.com
Back to search page Click to download printable version of this guide.

5.6.2.1. Geometry

The geometric model must be set up for both the RF and multipacting problem prior to running the RF analysis, because the boundary conditions used in the latter are written into the field file during the former, hence they need to present on the mesh used for the RF problem.

An initial driven-frequency analysis should use only one port boundary condition and one driving frequency.

Particle simulation uses emission and possibly other boundary conditions that are enabled if you are setting up a PT3p or PT2p problem, so the general strategy is to completely set up the RF problem, and then add whatever boundary conditions you need for the particle simulation.

Please send email to awr.support@ni.com if you would like to provide feedback on this article. Please make sure to include the article link in the email.

Legal and Trademark Notice