Go to www.awrcorp.com
Back to search page Click to download printable version of this guide. Attributes

In PT3p and PT2p geometries, no boundary condition is applied to the exterior of the structure by default, as listed in “Default Boundary Conditions”. To do a multipacting simulation you should specify at least one emission surface in your model (otherwise all particles terminate on first impact with the boundary). Typically you put emission boundary conditions in areas where you suspect multipacting might occur and not in other areas, but they may be placed on any external surface.

Please send email to awr.support@cadence.com if you would like to provide feedback on this article. Please make sure to include the article link in the email.

Legal and Trademark Notice