Description

Samples a field along a specified line. A measurement is then often taken of the annotation to allow the inspection of the samples in either a table or chart.

Annotation Types

Field

Parameters

Label - A unique name that identifies the filter. (IFilter/Label)

Point 1 - [LENGTH] – Start point of the sampling line. Defined in the world coordinate system. (ICutLineFilter/Point1)

Point 2 - [LENGTH] – End point of the sampling line. Defined in the world coordinate system. (ICutLineFilter/Point2)

Resolution - Number of points along the line to sample. (ICutLineFilter/Resolution)

Trim at Domain Boundary - If true, the output of the filter will be trimmed such that only the portion inside the corresponding mesh is maintained. (ICutLineFilter/Trim)

Example(s)

User Interface Button

Requirements

Number of planes must be greater than 0.

Example Script

Config_1 = FieldAnnotation_1.Get_IFieldAnnotation().GetConfig()
ClipFilter_1 = Config_1.Get_IAnnotationConfig().NewFilter("CutLineFilter", "Cut Line_1")

Scripting Interfaces

“ICutLineFilter”
“IFilter”